Home >> Internet Games >> PlayStation 2

How to Reconnect the Ribbon Cable in the PS2

The Sony PlayStation 2 ribbon cable allows the external "Eject" and "Reset" buttons to function. If it is disconnected, these buttons will not work. When you need to reconnect the cable, you can do so with little effort. The ribbon just slides into a few slots, and no other parts are needed to get the ribbon to stay in place.

Instructions

- 1
  Power down the PlayStation 2.
- 2
  Unplug all cables connected into the back of the PlayStation 2.
- 3
  Pry the screw caps off the bottom of the PlayStation 2 with a flat screwdriver.
- 4
  Unscrew the screws that were under the screw caps with a Phillips screwdriver.
- 5
  Pull the bottom half of the system off the top half. Be very careful so you do not scratch anything.
- 6
  Look for the ribbon cable near the area where the "Eject" button is. Slide one piece of the ribbon cable into the small slit in the side of the internal component of the PlayStation 2. Place the other end in the slot by the "Eject" button.

PlayStation 2