DIY Video Game Wheel Stand

Place a plastic tarp on the floor. Place the laminated pine square face down on the tarp. Measure down the length of the wood from the upper left corner to the bottom left corner. Make a dot at the halfway mark. Measure 2 inches in from the dot and make an ̶0;X.̶1; Measure 1 inch across from the ̶0;X̶1; and make another ̶0;X.̶1; Repeat this procedure at the other side of the square.

Drill a hole into the wood through each ̶0;X̶1; using a power drill. Stand one of the two wood beams on the tarp with the top angled to the left. Line up the top of the wood beam with the holes in the left side of the square. Run wood screws through the holes in the square. Screw the wood screws into the end of the wood beam with an electric screwdriver.

Stand the other wood beam on the tarp with the top angled to the right. Line up the holes on the right side of the square with the end of the beam. Run wood screws through the holes in the square. Screw the wood screws into the end of the wood beam with an electric screwdriver.

Place a folding chair in front of the television that is attached to the video game console. Stand the television tray in front of the chair. Place the stand you have made on the tray. Place the steering wheel on the stand with the wheel facing the chair. Plug the steering wheel accessory's plug into the game controller port on the video game console. Sit down and grip the wheel.