How to Refurbish Antique Trunks

Clean the trunk. Brush the trunk's surface to remove as much loose dirt and dust as possible. Dab off the rest with a damp sponge. Scrape the old paper lining out of the inside. Wipe out glued on pieces with a damp cloth. Scrape away as much of the old glue as possible. Leave up the lid and let the trunk's interior dry completely.

Banish odors. Put an open bag of kitty litter inside the trunk and close the lid. Leave the litter undisturbed for a week.

Pull off the canvas covering. Slip the razor knife blade under a corner of the canvas between it and the wood underneath. In this manner, trace around the perimeter of the trunk top. Slide your thumb under a corner of the loosened canvas and slowly pull it off. Repeat the same process on the sides until you remove all the canvas and expose the wood underneath. Scrape off any hardened glue on the trunk's surface.

Remove rust. Use a wire brush to remove the heaviest rust from the metal or brass hardware, locks and handles. Take off areas of lighter rust with steel wool. Rub in a circular motion and work on one small area at a time. Wipe away loose rust with a clean, dry, cloth or soft-bristled paintbrush.

Sand the trunk. Sand the wooden parts of the trunk using medium-grade sandpaper first. Finish sanding with fine grade. Avoid scratches and gouges by sanding with the grain.

Refinish the wood. Brush on a mixture of tung oil and mineral spirits or, for a more durable finish, apply water-based polyurethane. Both products can be purchased at any hardware store. Use long, even brush strokes and allow the finish to dry thoroughly before using the trunk.

Replace broken hardware. Purchase replacement parts for broken locks, handles and other brass or metal parts as well as leather handles. Reproduction hardware is available from many online dealers. You may also shop flea markets, garage sales and antique shops to find antique hardware that matches what was used on your trunk.