Home >> Collecting >> Gun Collecting

Tech Force Rifle Scopes Installation

Tech Force scopes are primarily designed for use on air rifles. The Tech Force scope does not come equipped with scope rings; you'll need to purchase scope rings to install your scope. The vast majority of air rifles have grooves cut into the top of the gun for the easy installation of 3/8-inch dovetail scope mounts. The tools necessary for installing your Tech Force scope should be included with your scope mount. Before installing your Tech Force scope, make sure that your air rifle is unloaded.

Things You'll Need

3/8-inch mount and rings for 1-inch scope tube
Allen wrench (supplied with scope rings)

Instructions

- 1
  Loosen the mounting screws, without completely removing them, at the base of your scope rings to allow you to spread the bracket apart. Place the bracket on the grooves on top of the rifle and tighten the mounting screws.
- 2
  Use the Allen wrench (supplied with your scope mount) to remove the top halves of your scope rings. Place your scope onto the rings and reattach the top halves, but do not completely tighten them.
- 3
  Position your scope so that you have sufficient eye relief and that the crosshairs appear straight across and straight down, when viewed through the scope. When your scope is positioned as desired, finish tightening the tops of the scope rings.

Gun Collecting