Home >> Collecting >> Gun Collecting

How to Mount Ruger Rings

Ruger firearms produces a variety of types of rifles -- available in semi-automatic, breach loading and bolt action -- to meet the needs of sportsmen and professionals alike. While Ruger does not produce its own scope rings, all Ruger models are compatible with most commercially produced scope rings. SR-556 rifles, and certain models of the Mini-14 line, are equipped with tactical rail-mounts which are compatible with tactical rings. Before mounting scope rings to your Ruger rifle, check that the weapon is unloaded.

Things You'll Need

Small slotted screwdriver (for traditional scope rings)
Standard slotted screwdriver (for tactical scope rings)

Instructions

Traditional Dovetail Rings
- 1
  Locate the four plug-screws on top of the upper receiver. Two screws will be located in front of the rifle action, and two behind. Remove them with your small, slotted screwdriver.
- 2
  Place the mounts of your scope rings into position on top of your rifle. Use the supplied screws to tighten them securely.
- 3
  Place the bases of the scope rings in the top of the mounts; the rings should be parallel with a barrel. Rotate the rings 90 degrees until they lock in place.
Tactical Rings
- 4
  Loosen the retention screws at the base of your tactical rings by hand. Widen the mounting bracket.
- 5
  Place the tactical scope rings on the rail mount. The retention screws should fit in the slots that are cut across the rail mount.
- 6
  Align the mounting bracket over the sides of the rail mount and tighten the retention rings. After you have tightened them, use a screwdriver to turn the screws and additional quarter-turn. Do not overtighten.

Gun Collecting