Hobbies And Interests
Things You'll Need
Instructions
Understand how bristle boards are made. Bristle board construction begins with long ropes of tightly bound sisal fibers 2-inches in diameter, wrapped in light-weight paper. Biscuits about 1 1/2-inches thick are sliced from the ropes. Many biscuits are glued to a round sheet of particle board and tightly compressed with a permanent metal band. This process arranges the sisal fibers at right angles to the backer board. The face of the biscuits is sanded and painted in a prescribed pattern. A movable wire divider called a ̶0;spider̶1; delineates scoring areas is attached to the face of the board.
Rotate the bristle board frequently. This reduces and distributes the wear in the highest scoring areas of the dart board. Remove the wire number ring. A bristle board is mounted on a centered pivot point. Rotate the board clockwise so the next black section is at the top of the board. Replace the number ring with 20 at the top and the bristle board is ready for play. Rotate as often as once a week, depending on the amount of play on your board.
Brush the face of the bristle board daily with a soft paintbrush to remove dust and bits of sisal that are pulled from the board.
Spray the surface of the board very lightly about once a week. In climates with very hot, low humidity, bristle boards tend to dry out. Do not over-spray as this will cause the board to swell up and cause the spider to bind.