Ladder Golf Building Instructions

Ladder Construction

• 1

  Cut with a saw, or purchase them pre-cut, seven 2-foot and eight 1-foot PVC piping pieces.

• 2

  Paint sections of the piping if you want to personalize the look of your set.

• 3

  Place elbow connectors on both ends of a 2-foot section of piping.

• 4

  Point connectors in the same direction and place 1-foot pieces of piping into the open ends, then place a T-connect on the end of each.

• 5

  Angle to T-connectors inward until they are facing and connect with a two-foot piece of piping. Repeat steps 4 and 5 until there is a ladder structure with two parallel lengths of 3-foot piping combined with three 2-foot pieces of piping. This is the ladder portion of your game set.

Ladder Base

• 6

  Place elbow connectors to the end of a 2-foot section of piping.

• 7

  Point connectors in the same direction and add a T-connector to the end of each, with the diverging connection angled upward and facing perpendicular to the piping to which it is connected.

• 8

  Connect 2-foot piping pieces to the parallel-facing connectors and place elbow connectors on the open ends.

• 9

  Angle elbow connectors toward each other and connect with a 2-foot piece of piping.

• 10

  Connect the open connectors running perpendicular to the piping with the ladder section. The ladder portion of the set is complete. Repeat sections 1 and 2 to complete the second ladder.

Golf Ball Bolo Construction

• 11

  Drill a hole in a golf ball.

• 12

  Tie the end of a piece of nylon rope and run the open end through two golf balls.

• 13

  Measure off enough rope to separate the two balls on the rope by 12 inches, then cut the rope and tie the open end. This is the golf ball "bolo".

• 14

  Repeat steps 1-3 until you have 6 "bolos".