Home >> Hobbies >> Aviation

E-flite Tensor Instructions

The E-flite Tensor is an ultra lightweight remote-controlled airplane designed for the RC enthusiast. It is particularly lightweight due to the fact that, other than the engine and propeller assembly, it is almost completely made of Styrofoam. This not only allows for greater flight control but it also quick setup. In fact, you can set up up your E-flite Tensor and be flying it in a matter of minutes.

Instructions

- 1
  Remove the contents of the E-flite Tensor from its box and lay them out in front of you. You will have the two wings (for the bi-plane assembly), the body of the unit, two struts and the propeller and motor assembly.
- 2
  Slide the two wings into the body with the decals facing up.
- 3
  Insert the two struts on either side of the body of the plane. Connect the tabs at the ends of the struts into the thin slots on the wings.
- 4
  Insert the motor assembly into the compartment on the bottom of the unit until it snaps in place.
- 5
  Insert the propeller in the compartment at the nose and push it in until it locks in place.
- 6
  Charge the RC battery with the included cable.
- 7
  Place the RC plane on a large area ideal for takeoff, such as a parking lot or empty street.
- 8
  Press the "Power" button on the included controller and use the controller sticks to pilot the plane.

Aviation