Hobbies And Interests
Home  >> Hobbies >> Aviation

How to Bind a Walkera Helicopter to a Transmitter

Communication between your transmitter and receiver is essential to a successful flight. The slightest loss of control due to interference is enough to cause a catastrophic collision. Binding your transmitter to your receiver will establish a bond between them via radio frequency. Learn how to bind your Walkera helicopter to your transmitter to experience exceptional control.

Instructions

    • 1

      Move the throttle stick to the lowest setting (all the way down), and then slide the throttle trim to the bottom position. Slide the rudder trim to the center position to allow equal adjustability in either direction.

    • 2

      Connect the battery to the receiver, and then turn on the transmitter within three seconds of the receiver's LED illuminating red. The LED should start blinking when the transmitter is turned on.

    • 3

      Wait while the power indicator on the transmitter is blinking---do not move anything on the transmitter until it stops. Move the sticks when the transmitter power light becomes solid red.


https://www.htfbw.com © Hobbies And Interests