Home >> Hobbies >> Aviation

How to Remove the Battery in a JR 10X

The JR 10X is an advanced RC helicopter PCM radio system that features a LCD touchscreen, PC connection interface with proprietary software, digital trim controls and a memory capacity for up to 10 separate models. The JR 10X also includes a removable 1100 mAh transmitter battery and a 1400 mAh airborne receiver battery. You might need to remove the battery packs from the transmitter and receiver system when replacing or upgrading the cells, or if you are using aftermarket charging systems.

Instructions

Transmitter Battery Pack
- 1
  Slide the center-mounted "ON/OFF" switch to the "OFF" position.
- 2
  Examine the bottom rear of the transmitter and locate the rectangular-shaped battery compartment.
- 3
  Hold the transmitter upside down and place both of your thumbs on the battery compartment cover.
- 4
  Slide the battery compartment cover off the transmitter to expose the battery pack. Lift the battery pack directly out of the transmitter.
Receiver Battery Pack
- 5
  Examine the helicopter and locate the canopy mounting points.
- 6
  Remove the canopy and set it to the side. Locate the small battery pack connected to the power switch harness.
- 7
  Disconnect the battery back wiring connector from the power switch harness.
- 8
  Remove the battery pack from the helicopter.

Aviation