Things You'll Need
Instructions
Determine where to mount the ESC.
Tape the ESC to the RC aircraft using thick servo-tape.
Secure the engine onto the engine mount using bolts.
Measure the ESC wires to the engine connector located on the engine.
Cut the ESC wires at the appropriate lengths with wire cutters.
Remove 1/4 inch of the ESC wires' casings with wire strippers.
Tin the wires with solder.
Insert the wires into each of the motor's connectors. These connectors are the metal square brackets with holes in the center located on the motor.
Solder the wires to the metal connectors.
Cut the remaining wire so that the wires are flush with the connectors.
Program the ESC according the ESC owner's manual.
Connect the receiver wire to the ESC's receiver port. These wires and ports are labeled.