Hobbies And Interests
Things You'll Need
Instructions
Decide your operating frequency. This should probably be the lowest frequency that your license class allows, in the sub band corresponding to your desired operating mode. For example, if you are a Technician and wish to operate SSB phone on 10 Meters, you should use 28.300 MHz as your starting frequency. If on the other hand you would like to experiment with your CW privileges on 40 Meters, use 7.025 MHz.
Calculate the correct wire length in feet by dividing 468 by the operating frequency, in megahertz. In the above examples, 28.300 MHz would be 16.537 feet and 7.025 MHz would be 66.62 feet. Rounding to the nearest half foot is fine, but add about 6 inches to facilitate making attachment points . With the cutters, cut the wire to the calculated length, then fold the wire in half and cut it again in the exact center.
Using the knife, strip one end of each wire if insulated, or scrape it to prepare for soldering, if bare. Attach that end of one wire through one of the holes in the insulator, and twist it into a loop. Repeat for the other wire, in the other hole.
Strip a few inches of the end of the coax that does not have the connector, and separate the center conductor from the braid. Solder the center conductor to where you twisted the loop on one of the wires (near the insulator), and solder the braid to the other wire in the same location. Tape up this connection to waterproof it, or use Coax-Seal as directed.
Make a loop in the free end of each wire, attaching it to the other two insulators if used, or just tie the rope to the loop if you are only using one insulator.
Temporarily hang the dipole for tuning. You can either hoist it by the ends in the flat-top configuration, using the ropes you attached in the previous step; or hoist it by a third rope attached to the center insulator, as an inverted-V. If you hoist it as an inverted-V, pull out the ends and stake their ropes to the ground, keeping the wire ends well above ground.
Connect the other end of the coax to your transmitter or antenna analyzer, and check the SWR at your start (lowest) frequency. Then check it at the high end of your frequency range. SWR should be higher at the lowest frequency. Clip wire a few inches at a time from both ends, checking SWR as you go, and making sure you don't go too far by making the SWR too high at the upper frequency!
Once you are satisfied with the SWR, tighten everything so it doesn't move too much, and you're finished!
The SWR will probably be acceptable from the beginning, so you may decide to skip the tuning step, after checking it. An SWR not exceeding 1.5:1 across the range is fine, and even 2:1 is probably OK.