Home >> Hobbies >> Other Hobbies

How to Install a PM6 Lucky Top Hat

The Proto Matrix M6 paintball marker, also known as the PM6, has a removable bolt that you can modify with different parts. The top hat has an o-ring on both ends of the piece. You can replace the o-rings with a different pair, such as o-rings made by Lucky, to change how the PM6 operates. The Lucky o-rings increase the efficiency of the PM6 marker.

Things You'll Need

1/4 inch Allen wrench
O-ring remover
Lubricating grease

Instructions

- 1
  Remove the hopper, the air supply and discharge any built-up gas.
- 2
  Unscrew the bolt on the back of the PM6 using a 1/4 inch Allen wrench and pull the bolt out of the marker.
- 3
  Twist the rear cap, which is the longest piece on the outside of the bolt, to unscrew it from the top hat.
- 4
  Unscrew the top hat from the cylinder to remove it from the bolt.
- 5
  Remove the black o-rings from both ends of the top hat using the o-ring remover. You'll remove a total of two o-rings.
- 6
  Slide the Lucky top hat o-rings onto both ends of the top hat.
- 7
  Screw the top hat onto the cylinder, and then screw the rear cap onto the back of the top hat.
- 8
  Rub a small amount of lubricating grease on the Lucky o-ring between the top hat and cylinder, and on the Lucky o-ring between the top hat and rear cap.
- 9
  Slide the bolt back into the PM6 and tighten the bolt with the 1/4 inch Allen wrench.

Other Hobbies