Hobbies And Interests
Home  >> Hobbies >> Other Hobbies

How to Install Rear Steer on an Axial AX10

The Axial AX10 Scorpion is an off-road style remote-control vehicle. The car is capable of traveling over rough terrain, such as snow, mud and rocks. Adding rear steering to the unit expands its ability and traveling power. The least complicated way to install rear steering is to install a rear-steer kit during the initial construction of the remote-control car. You should only attempt this project if you have some knowledge of mechanical engineering basics.

Things You'll Need

  • Rear steering kit
  • Screwdriver
  • Hex wrench
  • Electrical tape
  • Soldering iron
Show More

Instructions

    • 1

      Fit the locker onto the center of the ring gear. Slide the ring gear onto the axle. Slide the end caps onto the axle. Fit the axle into the axle case. Fit the other half of the axle case over the ring gear and screw the two sides together using the enclosed screws.

    • 2

      Position one axle case facing down and the other facing up below the first. Screw one straight drive shaft to the right side of the top axle case.

    • 3

      Screw two more straight drive shafts to the bottom left and right of the top shaft. Screw one straight drive shaft to the top right of the bottom axle case.

    • 4

      Screw the ̶0;Y̶1; shafts to the center of each axle case.

    • 5

      Push the suspension links in place onto the left and right sides of each axle case, next to the straight drive shafts.

    • 6

      Fit the beadlocks inside the center of the back tires. Screw the locks in place with a hex wrench.

    • 7

      Attach the electronics tray to the bottom of the battery with electrical tape.

    • 8

      Position the wheel axles on each side of the car chassis. Screw the drive shafts and suspension links to the front and back sides of the chassis.

    • 9

      Fit the wheels in place onto the ends of the axle cases. Screw the wheels in place with a hex wrench.

    • 10

      Connect the red and black electrical wires to the battery. Connect the blue and yellow wires to matching color ports on the circuit board. Solder the ends of the wires in place.


https://www.htfbw.com © Hobbies And Interests