Things You'll Need
Instructions
Measure the width and height of a window in your house with a tape measure. Note the measurements on a piece of paper
Measure the 2-inch by 2-inch board to the width of the window. Cut two pieces to this size with a miter saw. Measure and cut two 2-inch by 2-inch boards to the height of the window, minus 4 inches.
Set the blade of the table saw to 1/2 of an inch. Position the guide of the table saw to 1-inch. Run each cut piece of 2-inch by 2-inch board over the blade to make a groove.
Measure and cut a piece of plexiglass to the width and height measurements in step 2. Place the groove of the cut pieces of wood on the edge of the plexiglass.
Drill a pilot hole at each corner where two boards meet with the power drill. Secure the boards with the screws using the power drill.
Peel off the backing and place the plastic window sticker on the plexiglass. Set the completed window up on display.