Hobbies And Interests
Clamp Lock Feedneck
The clamp lock feedneck is the part that fits on top of the Diablo Slayer. The part secures the loader, or feeder, securely to the paintball gun. The clamp lock snaps into place and an Allen screw secures the loader to the top of the gun. This eliminates any movement of the loader and allows the paintballs to fall down into the gun for rapid firing.
Composite Frame
The composite frame part is the hand grip and trigger assembly of the Diablo Slayer. The grip commonly wears down on the paintball gun and requires replacement. You can slip the worn stock and trigger assembly off the main body marker. By removing a few fastening screws, the hand grip and trigger assembly slides off the back of the gun. The new hand grip is metal and slips right into place.
Marker Body
A marker body is the part that slides over the barrel of the Diablo Slayer. The part comes in three different colors: red, blue and silver. The marker body is purely a cosmetic part. The paintball gun can work without the part and the basic Diablo Slayer does not come with it.
Parts Kit
The parts kit is an combination of all the mechanical parts inside the Diablo Slayer. Replacement screws, gaskets, O-rings, springs and other smaller parts comes with the parts kit. This kit allows you to completely overhaul or rebuild the internal parts of the Diablo Slayer.
Battery
The Diablo Slayer battery is 9 volts and rechargeable. It fits under the grip panel. When replacing, you must remove three panel screws to gain access to the old battery. Once you have removed the old battery, disconnect the terminal. The power wires or terminals slip off the battery posts. Install the new battery and replace the grip-panel screws.
Propellant Cylinder
The propellant cylinder is the part of the Diablo Slayer that holds the gas. The cylinder easily screws on and off when refilling the liquid carbon dioxide. An indicator strip comes with the propellant cylinder so you will know when you are getting low on propellant.