Home >> Hobbies >> Other Hobbies

How to Make Wooden Ski Bindings

Vintage wooden skis that were used for cross-county travel do not have modern bindings which secure the boot to the ski. These skis have a binding that is made of a leather or rawhide. If you are making vintage wood skis for cross-county travel, a similar type of binding can be used. To do this, you will first need to find the leather or rawhide to use for the binding.

Things You'll Need

Ski boot
Measuring tape
Rawhide strap
Leather punch
Hammer

Instructions

- 1
  Measure around the center of the ski boot at the foot with the tape measure. Make a note of the measurement.
- 2
  Transfer the measurement in Step 1 to the rawhide strap. Cut two pieces of rawhide strap to the measurement of the ski boot.
- 3
  Place the rawhide strap over the top at the center of the wood ski. Align the strap so it is equal in length on each side of the ski.
- 4
  Make a mark for two holes on the rawhide. Repeat this step on the second rawhide piece. Remove the pieces of rawhide from the ski.
- 5
  Make a hole in the ski using the leather punch and a hammer. Position the leather punch over each mark and then strike it with the hammer.
- 6
  Place each leather strap back over the wood ski. Insert a screw into each hole and then tighten using the power drill.

Other Hobbies