How to Program the JR XP7202

Airplane

• 1

  Press and hold the select button and the down button of the scroller (on left side of LCD screen). Wait until the device enters into the System Setup mode. Use the adjust scroller (on right side of LCD screen) to highlight the ACRO (airplane) option and then press the clear button to select the model.

• 2

  Press and hold the select button and the down button on the scroller (found to the left of LCD screen) to enter setup mode and then press the two buttons again to enter into function mode. Press the up or down key until "Reversing SW" appears on display. Use the select button to change between channels 1 through 7 and then use the right adjust scroller to change between the normal and reverse servo functions. Press the clear button to return to the main menu once you have made the necessary adjustments to your personal preferences.

• 3

  Press and hold the select button on the down button of the left-side scroller to enter the function mode. Press up or down until "Travel Adjust" is displayed. Use the select button to choose the channel you wish to adjust. Use the "Increase" or "Decrease" buttons to change the throw in either direction.

Helicopter

• 4

  Enter into the system setup mode by pressing and holding the select button and the down button of scroller (on the left of the LCD screen). Use the adjust scroller (on the right side of LCD screen) to highlight the Heli (helicopter) option and then press the clear button to select the model.

• 5

  Press and hold the select button and the down button of the scroller to the left of the LCD screen to enter into function mode. Press up or down until the LCD displays "Reversing SW." Use the select button to change between channels 1 through 7 and then change between the normal and reverse functions with the scroller on the right side of the LCD.

• 6

  Press and hold the select button and the down button of the scroller on the left side of the LCD. Press up or down until the LCD displays "Travel Adjust." Press the select button to choose the channel you wish to adjust and then press "Increase" or "Decrease" while holding the corresponding switch or stick in the direction you wish to adjust servo travel.

• 7

  Press and hold the select button and the down button of the scroller on the left side of the LCD to enter function mode. Press up or down until the LCD displays "Pitch Curve Norm." Use the select button to choose the stick position you wish to adjust and then press "Increase" or "Decrease" to adjust the pitch value of that stick position. The recommended initial pitch settings are: L= -4, 2 = 5 and H = 9.

• 8

  Press and hold the select button and the down button of the scroller on the left side of the LCD screen. Press up or down until LCD displays "Throttle Curve Norm" and then press select to choose the stick-position throttle you wish to adjust. Press "Increase" or "Decrease" to adjust the throttle value.