How to Shape a Felt Cowboy Hat to Bull Rider Style

Fill a large pot half full with water. Heat the water to boiling over high heat. Turn the heat to medium when the water begins to steam.

Hold a felt cowboy hat over the steam. Turn the hat slowly to ensure that the entire crown is exposed to the vapor. Remove the hat from the steam when the felt has softened.

Spray a hat-stiffener spray over the top surface of the hat. Turn the hat as you spray it to ensure even coverage. Let the stiffener sit on the hat for 30 seconds. Brush over the hat's surface with a soft brush to remove any excess stiffener.

Push the top of the crown down to create a 1-inch to 1-1/2-inch tall ridge around the edge. Pinch gently around the edge of the crown to enhance the ridge.

Place the hat on a wig form. Gently press the hat onto the form to create a rounded bump in the center of the crown. Do not allow the center to rise above the outer edges. Allow the hat to dry.

Shape the brim by steaming, as in Step 2. When the felt has softened, place your hands at either end of one side of the hat's brim. Position your hands so your thumbs are on top and your fingers underneath the brim. Gently bend the brim upward in a rolling motion using your thumbs as a hinge point to create a gentle curve in the brim. Repeat on the opposite side.

Set the hat back on the wig stand and allow it to dry for one to two hours. Do not move or wear the hat until it is completely dry.