How to Install an Ultradot Scope on a 1911

The Ultradot scope is a compact aiming device which projects a red dot aiming point onto the target. It is small and lightweight enough to mount on a 1911 pistol for enhanced target acquisition. The Ultradot is designed for the universal Weaver mounting system, so it fits any standard Weaver scope base. While it is possible to install a base on the top of the pistol's slide, this requires the services of a gunsmith to drill and tap the slide. Fortunately, there are mounts available that the pistol owner can install at home.

Things You'll Need

• Grip scope mount
• Gunsmith's screwdriver set

Show More

Instructions

1. • 1

     Remove the magazine and unload the pistol. Lay the pistol on a table or workbench with its right side facing up.

   • 2

     Remove the two screws which secure the right-side grip panel to the pistol. Grasp the grip panel and pull it off.

   • 3

     Lay the scope mount on the pistol so the holes align with the grip screw holes. Reinstall and tighten the grip screws.

   • 4

     Loosen the two mounting screws on the Ultradot scope. Set it on the top of the scope mount so it locks in place. Tighten the mounting screws.