How to Use Anderson Powerpoles in RC

Prepare the Wires and Connectors

• 1

  Using Powerpole connectors is suitable for any electrical application which requires current transmission of between 10 to 180 Amps. Anderson provide a selection of components which cater for this range of amperage. For most radio controlled models, a 20-Amp connector will be more than sufficient.

• 2

  Use the wire strippers to cut away the old power connectors from your battery pack and speed controller. Make sure that you cut each wire separately as cutting two battery wires simultaneously can lead to dangerous short circuits.

• 3

  Using the wire cutters, strip back the wires on both your battery pack and speed controller 1/4 inch. Twist the exposed wire with your fingers to prevent it from fraying.

Solder the Connection

• 4

  Cut one inch of solder from the reel and insert it into the metal portion of the Powerpole connector. Push the copper wire from your model into this connector along with the solder.

• 5

  Secure the wire in your helping hand device and heat the metal connector with a hot soldering iron. As you do so, you will notice that the solder will be sucked into the joint. Any excess solder will simply drop from the connector. Allow this joint to cool.

• 6

  Leave the joint to cool, test the connector by pulling it with your fingers. If it is secure, simply push the metal connector into the plastic housing. You will hear a click when the connector is located properly.

• 7

  Repeat this procedure for all of your battery packs and speed controllers. If you have a model which requires a regular change of motor, it is advisable to terminate the motor with PowerPole connectors too. Remember to use different colored connector housings to identify the polarity of your battery packs and electronics.