Home >> Hobbies >> Spectator Hobbies

DIY: 1960s Oil Light Show

During the 1960s, free-thinking people were experimenting. Music became a scene where young people were finding new ways to open their minds and creatively enjoy the sense-filled world around them. In response to the alternative, psychedelic music being played at these shows, groups of visual artists began experimenting with liquid light shows to entertain the listeners at events. Mixing oil and water on glass surfaces and projecting light through the colorful mixture became one of the most popular and iconoclastic forms of performance art during this time.

Things You'll Need

Overhead projector
Masking tape
2 5"-- 6" convex glass clock faces
Small mixing cups
Metal or wood stirrers
Clear mineral oil
Water
Nontoxic candy dye (various colors)
Food coloring (various colors)
2 eye droppers
Colored cellophane (various colors)
Projection surface/screen

Instructions

- 1
  Prepare your projector. The area where you place the material to be projected is called the stage. Mask off the stage using strips of the masking tape until you have a square in the center of the stage approximately 4 ½ to 5 inches across. This will give your fingers room to manipulate the glass clock faces without being seen on the screen.
- 2
  Adjust the size of the final image. Place the projector in front of the wall or screen that will be used for the show. Turn on the projector and move it back and forth until the square projected is of the size you want.
- 3
  Prepare your light show liquids. All liquid ratios and amounts are unspecific. For the best light show, it will take some experimentation before you find the right mixture of colorant to liquid that gives you the colors and transparencies you like best. To make your oil liquid colors, mix clear mineral oil with nontoxic candy dye in small cups using the stirrer to whisk the colorant into the oil. To make your water-based colors, mix water with food coloring in small cups. Make around three colors for each type of liquid.
- 4
  Prepare the convex glass clock face before projecting. Lay the larger of the convex glass clock faces down on the masked square of the stage. This will provide you with a mixing bowl for your colored liquids. Use one dropper for oil and one dropper for water. Experiment by dropping different amounts of oil and water into the glass mixing bowl.
- 5
  Prepare the final steps before projecting. The projector is made up of a light source, a stage and the projecting unit above the stage. Before the light show begins, or during the light show to change up the color scheme, you can wrap the colored cellophane around the projecting unit to tint the light's color.
- 6
  There are many ways to manipulate the light and color of the show once you have all the materials in place. Turn on the projector and watch how the oil and water mix and project on the screen. Add more oil or more water and spin the colors around by hand turning the outside of the glass bowl. Try placing the second, slightly smaller glass clock face over the surface of liquids resting in the first glass bowl. This will give the oil a pressed look. You can manipulate the pressure by squeezing the glass faces together, or, place more oil and water in the top mixing bowl to get a layered effect. Try spinning the two bowls in different directions.

Spectator Hobbies