How to Use a Refracting Telescope

Pick an observing site far from light sources. Porch lights, street lights and other sources of light pollution brighten the night sky, making faint objects difficult to observe.

Lay the tripod on the ground. Extend each tripod leg to the same length, and then tighten the thumbscrews on each leg to secure it in place. Stand the tripod upright. Loosen the thumbscrews on the tripod's mounting bracket. Insert the telescope into the tripod's mounting bracket, and then tighten the retaining screws.

Loosen the thumbscrew on the telescope's finder scope mount. Insert the finder scope into the mount, and tighten the retaining screw.

Aim the telescope at an astronomical target. Pick a bright object, such as the moon or a star. Raise or lower the tube, and move it from side to side to point the telescope in the target's general direction.

Look through the finder scope. Adjust the orientation of the telescope to center the object in the finder scope.

Insert a low-power eyepiece -- one with 75X or lower magnification -- into the telescope's focuser. Tighten the retaining screw to secure it in place. Look through the eyepiece and verify that the object is in the field of view. If not, look through the finder scope and re-center the object. Adjust the focuser knob until the object appears sharp in the eyepiece.

Insert a high-power eyepiece -- one with greater than 75X magnification -- into the telescope's focuser to study the object in greater detail. Adjust the focuser to sharpen the object in the eyepiece.