How to Use a Tasco Telescope

Observing with a telescope

• 1

  Place the telescope in a level, open area, unobstructed by trees, buildings and bright street lights and clear of ground clutter that could trip you during your observing session. Extend the legs fully and make sure that the telescope is stable and that the telescope tube moves freely with just a slight amount of resistance.

• 2

  Select an eyepiece with the largest number marked on the side (you will probably have a 9 mm and a 25 mm) as this will give you the widest field-of-view and will make finding your target easier. Place the eyepiece in the draw-tube and lock it into place using the finger screw on the draw-tube.

• 3

  Select a target (begin with the moon) and gently move the telescope tube to align it with the target by sighting down the length of the telescope. When you get the telescope roughly aligned, use the small finder scope on the side of the telescope to make any fine adjustments to the alignment.

• 4

  Lock the telescope into place by finger-tightening the locks found on the mount so that the telescope does not move. Make final adjustments to center the target in the eyepiece using your hand or the tracking knobs. Because the moon is relatively close to Earth, only a portion of it may be visible in the eyepiece.

• 5

  Rotate the focusing knob until you have a clear image. After focusing, remove your hands from the telescope and allow the wobble to stop so that you have a steady view.

• 6

  Follow the movement of the target across your field of view as the earth rotates by using the tracking knobs or gently guiding the telescope with your hands.

• 7

  Make focus adjustments periodically to keep your target view sharp and clear. You may need to reposition your seat depending on how the telescope is pointed.