Game Country Deer Feeder Instructions

Power Up And Self-Program

• 1

  Install the six-volt lantern battery.

• 2

  Observe the status LED on the control panel. After it flashes the fourth time, the self-program is complete. In the self-programmed mode, the unit dispenses food for eight seconds at daybreak and for eight seconds one hour before nightfall.

• 3

  Verify that sufficient food is contained in the storage container to dispense food over the desired time span.

Programming Additional AM Feedings

• 4

  Power up the unit and press and hold the "AM" button until the Status LED lights. Release the "AM" button. In the AM mode there are six time slots programmable for feeding: one at daybreak, then five additional times at 30-minute intervals after daybreak.

• 5

  Press and release the "AM" button. The Time Slot LED will blink once, indicating the first time slot for the day. Press and release the "Feed" button once to toggle that time slot "On" for feeding. Press the "Feed" button again if you wish to toggle the first time slot "Off" for feeding. Press and release the "AM" button to advance to the second time slot of the day and use the "Feed" button to toggle it "On" or "Off."

• 6

  Continue the procedure until all six time slots in the AM mode have been programmed.

• 7

  Exit the AM programming mode by depressing and holding the "AM" button until the Time Slot LED turns off.

Programming Additional PM Feedings

• 8

  Power up the unit and press and hold the "PM" button until the status LED lights. Release the "PM" button. In the PM mode there are six time slots that can be programmed for feeding: one at nightfall, then five additional times at 30-minute intervals before nightfall.

• 9

  Press and release the "PM" button. The Time Slot LED will blink once, indicating the first time slot for the day. Press and release the "Feed" button once to toggle that time slot "On" for feeding. Press the "Feed" button again if you wish to toggle the first time slot "Off" for feeding. Press and release the "PM" button to advance to the second time slot of the day and use the "Feed" button to toggle it "On" or "Off." Continue the procedure until all six time slots in the PM mode have been programmed.

• 10

  Exit the PM programming mode by depressing and holding the "PM" button until the Time Slot LED turns off.

Programming Motor Run Time

• 11

  Press and hold the "Run" button until the Status LED illuminates, then release the button.

• 12

  Immediately press the "Run" button to program the desired motor run time in seconds up to a maximum 45 seconds. Each press of the "Run" button increments one second of run time.

• 13

  Press the "Test" button to exit the run time mode and verify the time setting.