Things You'll Need
Instructions
Draw the carving design on a piece of paper. Make sure the design fits inside the dimensions of the gypsum block. Draw the design from the front, back, sides, top and bottom. Cut out each drawing.
Tape the drawings on the appropriate sides of the gypsum block. Example: Place the arms and legs so they face forward on both sides when carving a person or animal. Trace around the outside of each cutout. Remove the cutout once the tracing is complete.
Cut away the large areas of gypsum using a craft knife, dremel or jeweler's flat file. Be careful not to push too hard because the gypsum will crack and break. Work from all sides to get the rough shape of the sculpture.
Make smaller cuts as the design is taking shape. Use the different shapes of the jeweler's files to create indentations and texture. Jeweler's files shapes include flat, round, square and half-round.
Sand the piece lightly with sandpaper to finish.