How to Make a Hanging 3D Solar System

Select a sheet of cardboard large enough to hold the eight planets. One suggested size is a 20-by-20 square, which can be made by taping two sheets together.

Paint the cardboard black. After it is dry, use chalk to draw a 3-inch circle in its middle, to create a placeholder for the sun.

Create a series of concentric rings around the circle. The rings should be 2 inches apart. Lightly mark the places on the circles where the planets will be placed, using the solar system picture as a guide.

Select a 2.5-inch Styrofoam ball to represent the sun, and a 1.5-inch ball for Jupiter. Use 1-inch balls to represent Saturn, Uranus and Neptune. Choose 0.5-inch balls for the Earth, Mars, Venus and Mercury.

Create Saturn̵7;s ring. Cut a Styrofoam piece into a circle that is 1.5 inches in diameter. Remove part of the middle part so that it forms a ring. Glue it onto the middle of a 1.0- inch Styrofoam ball.

Paint the Styrofoam balls. Choose yellow for the Sun and for Venus. Paint Mercury orange and Mars red. Choose green and blue for the Earth, and green and dark blue for Uranus. Paint Neptune sky blue. Finally, paint Jupiter yellow and brown, and Saturn brown but with a yellow ring.

Attach the balls to the cardboard. One way to do this is to cut holes in the cardboard, and then push the balls halfway through them. Add glue to make sure that they stay in place. Another way is to cut each Styrofoam ball in half, and then glue one of the halves to the cardboard̵7;s surface. For Saturn, line the ring so that it is flush. After using either method, repaint any areas that need them.

Create two holes on each side of the cardboard. Thread a piece of string through both of them. Hang the cardboard solar system on a hook.