Things You'll Need
Instructions
Place the sensing end of your pressure transducer into the feed (the solution that is being filtered) on the outside of the membrane. Read the value displayed on the pressure transducer and write it down. This is the feed pressure.
Measure the pressure of the retentate. The retentate is the part of the feed that did not pass through the membrane the first time. It is collected into the feed reservoir to be delivered to the membrane again. Place the pressure transducer in the retentate between the outside of the membrane and the feed resevoir. Write down the measurement. This is the retentate pressure.
Measure the pressure on the opposite side of the membrane. The last two measurements were taken on the outside of the membrane, in the feed and retentate. This measurement is taken on the inside of the membrane, in the permeate, the filtered fluid. Measure the pressure with your transducer by gently placing the sensing end in the permeate. Read the value on the pressure transducer and write it down. This is the permeate pressure.
Using your calculator, add the values for the feed pressure and the retentate pressure. Divide the sum by two and subtract the permeate pressure. The result is the transmembrane pressure.