Things You'll Need
Instructions
Measure the waist around your WWE figure. Add 1/2-inch to this length.
Lay out the black vinyl and measure the length of the belt. Flip the vinyl over and tape a quarter to the center of the belt to help you match the rounded shape of a real title belt.
Cut out the title shape with scissors or a utility knife. Cut around the quarter to make the curved shape. Remove the quarter and the tape when the strap is cut out.
Measure the center diameter of the title belt to know the size of the faceplate. Print out the belt image you want to use on photo paper.
Cut out a square piece of lamination film. Make sure the piece is slightly larger than the printout of the title belt faceplate.
Peel the end of the lamination film and attach to the end of a table. Lay the printout flat and then apply the lamination film on top of it. Press down as you go to remove any air bubbles.
Cut out the laminated faceplate shapes. Apply the faceplates to the front of the belt with super glue. Assure that they are centered on the title.
Apply gold fabric paint to create small studs and faux connection pieces on the belts. Lay the belt flat and wait for the paint to dry before displaying or using with your WWE action figures.