Things You'll Need
Instructions
Lay scrap wood on a flat surface. Measure and mark three rows of three dots approximately every 12 inches across. Measurements do not have to be exact; you can randomly arrange the nine dots evenly across the wood, if desired.
Drill holes approximately one-half-inch deep on each of the nine dots on the wood.
Dribble a small amount of epoxy glue into each hole.
Fit the screw of each table leg into each hole, turning and pushing so that each leg is flush with the wood surface.
Allow epoxy glue to dry, as directed by the manufacturer.
Paint the game board different colors, if desired, and allow the paint to dry.
Play ring toss by tossing the flying disks at the table legs, trying to catch the ring on the leg.