Cyclone Twist Waterslide Setup Instructions

Open your box containing the waterslide. Check for all of its components. You should have a waterslide, a numbered water hose assembly, a blower motor, three anchor bags, six waterslide stakes and four yellow stakes for the blower.

Clear your lawn of debris such as rocks, sticks and toys that could pop the waterslide.

Unfold the slide on your prepared location. Locate the numbered Velcro patch and ties on the top arch and along the slide. Attach the water hose assembly to the Velcro patch. Tie the hose assembly to the slide using the Velcro ties.

Attach the blower motor's mouth to the slide's yellow intake fitting. The fitting is on the left side of the climbing wall. Wrap the Velcro strap tightly around the mouth of the blower. Use the enclosed yellow stakes to hold the blower in place.

Find the five loops located on the bottom of the slide. Pound the orange stakes into the ground, ensuring that all five loops are securely held down. No part of the orange stakes should be visible above ground, as this will cause a tripping hazard.

Plug the blower into a grounded outlet. Turn the blower on by switching the motor from the "0" position to the "I" position. The slide should inflate within three minutes.

Fill the anchor bags with water and attach the anchor bags to the slide. You should place one anchor bag before the blower on the left side of the climbing wall and the other two on the back of the waterslide.

Wet the waterslide. Turn off the water and connect your hose to the hose assembly. Turn on the water. Adjust the water pressure as needed to ensure that the waterslide is continually wet.