Instructions for the Motorized Bumblebee Transformer

Assemble the Bumblebee. Align the arm posts and push the arm in while rotating until it snaps in place. The cannon arm goes on Bumblebee's left side. Attach the wings window side up to the loops on Bumblebee's shoulders. Insert the cannon into the cannon arm.

Switch the robot on with the "On/Off" switch on his back. Press the button on the Camaro hood for sound and movement. Press the button beneath the cannon arm to fire the cannon.

Remove the wings to begin the change into a car -- the wings will hang down from the robot's back. Lower and fold the arms down against Bumblebee's sides. Flip up the heel pieces on each leg. Rotate the wheels to the outside on each heal then flip the heel pieces down so the tires snap in place. Pull the tire out to turn the wheels. Flip the rear panel down behind the tire on each leg, and flip the back of the roof sides down over the rear panel.

Press and hold the buttons on each side of the leg above the wheels and slide the back end of the car up toward the robot's torso. Rotate out the two yellow wings on the bottom of the torso and pull them away from the sides of the body. Do not remove. Pull the two legs down from the torso and push them together to form the back end of the car.

Curl the hand in toward the inside of the right arm. Rotate the bottom half of each arm a half turn toward the inside. Press the arms into the sides of the body. Flip the two yellow wings that are sticking out at the sides up onto the sides of the car body. Flip the wheels at the shoulders out to the sides. Rotate the panels below the wheels up into position by the wheels.

Slide the roof down. Slide the top half of the hood up until the hood and windshield are in place. Press the panels above the front wheels in until they meet the hood. Slide the "wing" doors into place. There is a buckle loop on the inside of the front panels that the door panels slide into.

Flip the front end of the car over the robot's head. Press the front end sections into place so the bumper is aligned, then push the assembled front end up to the rest of the car.

Press the button on the hood for car sounds. The "On/Off" switch is now behind the driver's side door. Roll the car to activate headlights and music, stop the car to activate brake lights and sounds.