Home >> Toys >> Childrens Toys

How to Wire Up a Dora Power Wheels Jeep

Mattel has produced different models of the Dora Jeep Wrangler Power Wheels vehicle with similar specifications. All of the Jeep vehicles can seat two small children and provide hours of enjoyment for young riders. The Dora the Explorer Jeep Wrangler includes a 12-volt battery and charger. When fully charged, the power should provide at least three hours of use. The life expectancy of a battery ranges one to three years. Once connected under the hood of the Jeep, your Dora Power Wheels should be ready to ride.

Instructions

- 1
  Plug the charger connector into the corresponding socket on the Power Wheels battery. Plug the other end of the charger into a regular wall outlet in an open area like the garage. Allow the battery to sit upright on the floor while charging.
- 2
  Charge the battery for at least 18 hours before its first use. For subsequent charging, leave the battery plugged in for at least 14 hours. Charge the battery between every use. Do not leave it plugged in for more than 30 hours.
- 3
  Unplug the battery connector and wall charger once the battery has been charged.
- 4
  Open the hood of the Jeep to install the battery by turning the hood latches on both sides a quarter-turn.
- 5
  Pull the battery retainer bar forward and slide the battery into the battery compartment, releasing the battery retainer to secure it.
- 6
  Locate the motor harness connector and plug into the corresponding socket on the right side of the battery when facing the Jeep.
- 7
  Close the hood and secure by turning the latches.
- 8
  Charge the battery after use by plugging it in while installed the vehicle. The battery does not have to be removed from the Jeep to be charged. Simply disconnect the motor harness connector, plug the charger connector back into the battery and plug into the wall outlet.

Childrens Toys