Radio Flyer Bouncing Horse Assembly Instructions

Assembling a Radio Flyer Soft Rock and Bounce Pony

• 1

  Empty the contents of your Radio Flyer Soft Rock and Bounce Pony box onto your floor. Make sure your pony has all its pieces. Check the pieces against the inventory pictures provided in the Resource section of this article. If you are missing any pieces, return the Radio Flyer Soft Rock and Bounce Pony to the store.

• 2

  Connect the two sides of the plastic pony body. The pieces will fit together snugly and snap into place. Place your 9 m4 by 15mm screws into the pre-drilled holes on the right side of the pony. Screw them into place with avPhillips screwdriver. All the screws come with the Radio Flyer Bouncing Pony.

• 3

  Connect the two plastic ends of your rocker to the center middle piece. These ends will slide onto the center piece. Place the 4 m6x10mm screws into the pre-drilled holes at the back of your rocker. Tighten the screws into place with your screwdriver. Repeat this step with your other rocker.

• 4

  Fasten the two white short connectors to the long white rod. Position the larger, thicker opening of the connector toward the rod and push them over the end of the rod. Take two of the black pieces with the "Radio Flyer" logo written on it's side, and slide one of its open ends over each of the connectors until its at the middle of the connector. Repeat this step with the other white rod.

• 5

  Position one of the rods between the two rockers and rest it in the holes at the end of the rockers. Screw the rod into place by putting two of the m6 by 15mm screws in the pre-drilled holes on the other side of the rod on the outside surface of the rocker. Tighten the screws with the Phillips screwdriver. Repeat this step with the other rod for the other end of the rockers. The rockers are now connected.

• 6

  Connect the horse body from Step 1 to the rockers. The four "legs" on the horse body will connect to the rockers by sliding the hole on the black piece with the "Radio Flyer" logo over the "leg." Place the four rubber dowels over the end of each "leg." Place the m5 by 15mm screws in the pre-drilled holes at the end of the leg. Tighten the screws with the Phillips screwdriver.

• 7

  Place the soft body of the horse on the plastic body you just constructed. Using the Velcro straps, attach it under the plastic body. You have now assembled your Radio Flyer Soft Rock and Bounce Pony.