Hobbies And Interests
Things You'll Need
Instructions
Place one 2-by-4 flat piece on top of the flat 2-by-8 piece with the edges flush on one end. Place two 2-by-3 pieces side by side above the 2-by-4 piece. There should be a 2-by-1 section of the 2-by-8 piece left available.
Stack the tail fin base on top of the last section of the 2-by-4 piece with the flat side facing up and back. Place the remaining 2-by-4 piece next to the tail fin base. It should overlap and secure the two 2-by-3 pieces.
Place the following pieces in order from the edge of the tail fin base towards the other end of the structure: two flat 1-by-1 with conical connector thruster pieces side by side, a flat 2-by-2, then two flat stacked 1-by-2 pieces.
Stack two rivets on top of each other and repeat with the remaining two. Place each stacked set onto the ends of the thrusters, pointing away from the tail fin base. Attach one small cone to a cylinder, repeat and attach each to the other side of the thrusters.
Stack a 2-by-2 flat piece on top of the thruster base, creating a level surface between the square and the top of the tail fin. Position two 1-by-4 pieces perpendicular to the existing structure in the space between the square piece and the small rectangular piece.
Attach two of the six 1-by-1 pieces with side connector pieces along each edge of the 2-by-3 pieces, with the connecting edges facing out. Place the remaining two pieces along the same line, with the connecting edges facing the front of the plane. Attach two square corners without connectors to the connecting edges.
Attach the two small slanted and ridged pieces to the connecting edges facing out of each side of the plane. The thick edge should be flush with the perpendicular wing sections. Place the thick 2-by-4 in the space created.
Place a 1-by-2 piece on top of the edge of the thick rectangle, then place three flat 2-by-4 pieces along the length of the plane. Attach the first piece perpendicular to the plane, the second piece parallel and the final piece perpendicular.
Place the 4-by-1 fins side by side on top of the tail fin base with the slanted edges facing the front of the plane. Place the 6-by2 fins in the spaces on either side of the parallel 2-by-4 pieces with the slanted edges facing the front of the plane.
Place the following pieces along the top of the plane from front to back: small cone; large cone; 1-by-2 and 2-by-4 corner; a 3-by-1 left and right fin side by side to create a curved shape; two 1-by-2 pieces placed horizontally; a 3-by-1 left and right fin side by side to create a curved shape in the opposite direction; and two 1-by-2 pieces placed vertically.
Place two 1-by-3 pieces next to and parallel to the vertical 1-by-2 pieces, then attach a flat ridged 1-by-2 in the space above the vertical 1-by-2 pieces. Place another flat ridged 1-by-2 directly behind and above the horizontal 1-by-2 pieces.
Attach the two clear domed pieces to the front of the plane, and the two thick slanted pieces to the back of the plane on top of the 1-by-3 pieces. Place the two clear thin slanted pieces on top of the large slanted pieces. The slant on all four pieces should face the front of the plane.