LEGO 7942 Instructions

Create your Minifig by connecting the legs to the body, body to the head and head to the helmet.

Lay out the 10-by-2 grey piece that widens in the center. Turn it upside down. Attach two 2-by-2, flat, dark grey pieces with a rod sticking out to both ends.

Push the 1-by-1 flat grey piece with a bar into one of the two ends with the 3-by-2 flat grey piece on top. Secure the 1-by-1 flat grey piece with the curved extension into the other end with the 2-by-1 flat red piece on top.

Flip the construction around so it is now right -side up.

Make a stack with the 4-by-1 flat red piece on top and then the 4-by-1 flat white piece with the claws. The 1-by-1 flat red pieces go on either side of the next layer with the 2-by-1 flat grey piece in the center. The 4-by-1 dark grey piece goes on the bottom.

Add this stack to the top of the base, on the side with the red bottom. The white claws should face away from the other LEGO pieces. Attach the 4-by-1 red brick just in front of the stack.

Clip two 2-by-2 grey bricks with semicircles attached just in front of the last piece you added. Add the 2-by-1 white brick just in front again, in the center. Place a 6-by-1 red flat piece with raised ends at either side of the white brick.

Secure the 2-by-2 flat yellow piece in the gap between the two red pieces. Place the steering wheel, in the space in front of it.

Attach a pair of 2-by-2 grey bricks with semicircles attached in front of the diagonal red

pieces.

Connect the 4-by-2 dark grey arch-shaped piece to the front of the truck, which is on the opposite side of the white claws. Add a 1-by-1 white wedge piece in the top two corners, a 1-by-1 blue wedge into the bottom two corners of this piece and clip the 2-by-1 flat white grill piece in the center.

Push the smooth flat red piece with the claws into the claws at the back of the truck. Add a pair of 4-by-1 flat grey pieces at the very back center of the truck. Secure the L-shaped 4-by-1 red bricks to either side of these grey rectangles and a 4-by-1 white brick to both sides of the steering wheel.

Push the red piece attached to the claws so it clips into places at the back of the truck. Place a 4-by-1 red brick just behind the driver's seat.

Connect a 1-by-1 red brick to a 1-by-1 flat red piece with a claw ,and then do it again to make two pieces. Attach these pieces to either side red brick, behind the driver's seat.

Put the large smooth red square with the two connecting pieces at the very front of the truck; this is the hood. Attach the transparent windshield to the connecting circles on this piece.

Adjust your fireman into a sitting position and place him in the seat. Clip the roof piece, which is the large smooth red square with the two connecting pieces, into place above the driver.

Push the walkie-talkie into the claw on the left side of the driver. Connect yellow circle to the white tube with a handle and attach to the claw on the other side.

Attach the 2-by-1 white grill piece to the center of the 4-by-1 flat white piece. Put a 1-by-1 blue wedge piece on either side so the slope down towards the edges. Connect the whole thing to the two connecting circles at the back of the roof.

Push the wheels into the four rods hanging out the side of the truck.