Things You'll Need
Instructions
Clip the grey two-pronged Technic beam into U-shaped part of a brown double-balll joint piece. Slide a three-stud rod into the joint so it creates a long torso for the model.
Slide a black U-shaped connector between the prongs. Insert a two-stud rod into the prongs to keep the piece in place. The U-prongs should point upward. Place a brown double-ended joint connector in the U-connector and insert a two-stud rod to hold the piece in place.
Insert a grey pin, a black pin and a grey pin into the three upright holes on the front of the two-pronged piece. The black pin should be in the middle hole. Attach a grey L-shaped three-hole beam to the middle pin.
Insert a blue pin into the bottom of a red ball joint socket. Attach a brown leg piece to the pin. Insert a red L-shaped ball joint connector into the socket. Make two of these units, and attach them to the sockets on the middle of the model.
Insert a half-pin, dark grey, into the middle of a red double-socket piece. Clip a brown shell covering onto this pin. Clip a brown wedge-shaped double-jointed piece into one end of these. Attach a blue pin to another red socket joint and another leg piece to that. Make two of these units and attach them to the back of the model.
Push a three-stud rod into a blue spike piece. Push this through the head piece, at the front to form an eye. Attach a second eye piece to the other side. Flip the head over, and insert a yellow pin with teeth on the outside into the middle hole on the back of the head. Push the grey spinner housing onto the back of the model, with the lump on the piece facing the back of the model.
Push the beam attached to the bottom of the head into the front of the two-pronged torso. Push a two-stud rod through that first hole to keep the head in place, but don't yet flip the head over.
Clip the two grey claw-shaped pieces onto the grey pins at the front of the model. Loop the elastic band around the back of these two pieces so that the pincers snap back into position when you push on them. Flip the head over.