Hobbies And Interests
Instructions
Press one white (3x2) piece and one black (3x2) piece at a 90 degree angle from one long black (12x2) piece, covering the fourth and fifth rows. You should have what resembles a cross.
Repeat Step 1 to cover rows 6 and 7, and 8 and 9 of your long (12x2) piece. You should now have a half black and half white square in the center of this piece. Place once long black (6x1) piece on the outer black side of the square and a white (6x1) piece on the outer white side of the square.
Press a small (2x1) gray piece behind your square, over row 10 of your long (12x2) piece. Create the base of the van by pressing one gray (4x2) wheel piece behind the small (2x1) gray piece, and two (2x2) wheel pieces on the other end of the long strip. One wheel piece should be black on the side that you have black, and the other should be gray.
Place a large black (6x4) piece at the front of your van so that the first row is free, the second two rows are connected to your black and gray wheel bases, and the fifth and sixth rows are connected to the black and white square.
Place a long (8x2) piece behind and center of the front (6x4) piece. Cover all of this by one black (14x4) piece. The base of your van should be level and solid now. Put the wheels on your wheel pieces.
Put a white (4x1) piece along the front of your van. You will now be building the grill. Press a curved headlight piece onto both an extra wide black (2x1) piece and an extra wide white (2x1) piece, filling in the extra (1x1) space with small (1x1) pieces, white and black respectively, and covering these each with standard (2x3) pieces respectively.
Place the clear and clear yellow pieces and gray grill pieces into the standard (2x3) pieces to complete your headlights. Press two gray hinge pieces into the center bottom two notches of each headlight. Add the headlights to the front piece on your van.
Press your rim pieces in around your wheels to begin building the walls of the van. Press one small (2x1) black and one small (2x1) white piece on the front side of your rim pieces respectively. Connect this wall with two stacked (2x1) white pieces in the middle. Add your steering wheel piece between the remaining (2x1) space of the rim pieces.
Place one (2x1) white piece and one (2x1) black piece along the sides of your van, just behind the wheel rim pieces. At a 90 degree angle, place on (3x2) white piece and one (3x2) black piece. You should now have a driver's and passenger's section. Enclose this space with one layer of thin black and white pieces.
Enclose the back section of your van with one layer of thin black and white pieces. On one side, stack three (2x1) black pieces on the outer back of your rim piece. Do the same on the other side with a stack of three (2x1) white pieces. Continue these walls all the way to front cabin.
Stack two (2x1) black and two (2x1) white pieces to continue the wall across the front cabin. Press a windshield piece (6x1) centered over the steering wheel piece.
Finish enclosing your van by laying long (4x2) pieces over the top of the van. Secure the pieces underneath with thin (4x1) pieces connecting all of the pieces if needed.