Directions for Making a LEGO X-Wing

Instructions

• 1

  Snap a red four peg strip across the top of a three peg tan strip and two peg white strip. Place another two peg white strip on top of the bottom white piece with one peg hanging over the edge. Lay a four peg white piece with a tail on top of those.

• 2

  Take the two tan pieces with barrels on the sides and place a red piece with the hole in it across them. Snap a white two peg piece behind the red one. Place this piece under the tail you previously put together. Snap a two peg gray piece on the exposed two white pegs in the back.

• 3

  Place two more tan pieces with barrels on top of the tail making sure they are parallel with the bottom ones. Put a white two peg strip in front of the barrels on top.

• 4

  Put a white piece with a hole in it across the back part of the two barrel pieces. Place a white piece with a grill in front of that across the front peg of the barrels. Slide the white round cylinders onto the back ends of each of the tan barrels.

• 5

  Place a single round gray peg on top of the white piece with a hole. Take the four small, round tube pieces and place them on the front of each of the barrels.

• 6

  Take two of the one peg white pieces with a clip on each side and snap them together with a flat white piece with a red design on it. Make a total of four of these. Place the long white rods in one clip on each of the four wings.

• 7

  Attach two wings, opposite the end of the rod, to the middle of the tan barrels on each side. It should create an "X" look when finished.