How to Make a Simple Toy With Moveable Parts

Cut the bottom and top off the box with the scissors.

Reinforce all box corners and bent edges with the masking tape.

Poke holes in the centers of the two long sides of the box, and the center of the top of the box with the pencil.

Cut two round circles from the leftover cardboard box top to measure 2 1/2 inches in diameter, using the compass and scissors.

Cut a 1-inch by 1 1/2-inch rectangle from the leftover cardboard for a handle.

Poke a hole in the center of one circle with the pencil.

Poke a hole, 1/2-inch from the edge, in the other circle.

Poke two holes 1/4-inch from each short edge of the rectangle.

Cut a straw to measure 8 inches long. Thread the straw through one side box hole, the circle with the off-center hole, the other side box hole and one hole in the handle.

Cut a 2-inch section of straw and insert it in the second hole in the handle.

Thread another 8-inch straw through the box top hole. Attach the other cardboard circle to the bottom of the straw, which will rest on top of the cardboard circle inside the box.

Draw a shark on the poster board and cut it out. Glue it to the part of the straw that is sticking out from the top of the box.

Cut a square of poster board to fit over the front of the box. Draw waves on the poster board and glue it to the box.

Turn the handle to make the shark jump over the waves.