How to Build a Lego Halo Flamethrower

Build the Flamethrower's Handle

• 1

  Take one of the Flat 2x4's and attach the Plate 1x2 W. 1 Knob by aligning the 2-end of the plate with the 2-end of the Flat 2x4 (either end works).

• 2

  Connect the Plate 1x1 W. Upright Holder to the knob of the Plate 1x2 W. 1 Knob so the holder part extends away from the Flat 2x4, and not into its interior.

• 3

  Clip the stem of the T-piece to the holder of the Plate 1x1 W. Upright Holder.

Construct the Center of the Flamethrower

• 4

  Attach the Brick 2x1 to the flamethrower's handle lengthwise on the connecting dots right behind the handle.

• 5

  Connect one of the Flat 2x1 pieces lengthwise, directly on top of the Brick 2x1. Insert the Round Plate 1x1 into the middle of the four remaining connecting dots on the handle's Flat 2x4.

• 6

  Attach the orange Angular Brick 1x1 to the Round Plate 1x1 so the holder/knob faces outward, away from the interior of the Flat 2x4.

Finishing Touches

• 7

  Take the orange flame piece and thread the non-flame end into the holder-knob of the orange Angular Brick 1x1. The "flames" of the flame piece should be pointing out from the flamethrower's interior.

• 8

  Lay the remaining Flat 2x4 on top of the interior construction so that it lies exactly parallel to the Flat 2x4 that forms the base of the flamethrower.

• 9

  Add any decals or custom-paint the flamethrower--adding shark eyes and teeth lining the front side--to make it further resemble the M7057 used in Halo 3.