How to Build a Lego X-Wing Fighter

Place a flat white two-pronged rectangle infront of a flat yellow three-pronged rectangle so that they form a straight line. These will not be connected to anything yet. On top of these two pieces attach a four-pronged red rectangle and a two-pronged white rectangle so the one prong of the white rectangle is left free and overlapping the front of the bottom white rectangle. You should still have a straight-line design, only now it will be two flat piece high.

Attach a four-pronged white rectangle to the top of your design from Step 1, only attach it starting at the second prong so that it lines up with the bottom flat white rectangle. Next, attach another two-pronged white rectangle directly behind the four-pronged piece from this step. The end result should be a three-piece high straight line with one overlapping piece in the second section on the left and one overlapping piece on the top section on the right.

Start a seperate piece using one single-pronged red rectangle, one two-pronged white rectangle and two two-pronged yellow rectangles which have a small yellow cylinder attached to its side. Line up the yellow pieces so that the cylinders are on oppostie side, but so the two pieces are touching each other in the center. Attach the red and white rectangles to the top of the yellow pieces. Your ending design should be a two-piece high square that has a yellow cylinder attach to each of its side. Attach this piece by one prong on the red rectangle to the bottom of the top overlapping white piece from Step 2.

Attach two flat two-ponged yellow rectangles with the cylinder attachments to the top of the white rectangle from the seperate design you created in Step 3. These two pieces will line up perfectly with the two identical yellow pieces you used in Step 3. To each one of the now four yellow cylinders in the design, connect one single-pronged circle to the front of the cylinders and attach four connected single pronged circles to the back of the yellow cylinders. These will act as the X-Wing fighter's rocket boosters.

Attach the wings that create the X shape to the design. To do this, you need to create four small seperate but identical designs which you will attach to the middle of each of the four yellow cylinders. The design is very simple; start with two flat one-pronged white squares which have a C-shaped arm extension on them next to each other so the C shapes are on opposite sides but so the two pieces touch in the center. Snap one flat white two-pronged rectangle on two of the two squares so they are now connected. Attach one small white rod in the left C-shaped arm of the design.

Snap the C-shaped arm that does not have the white rod in it to the middle of each of the yellow cylinders. After attaching these pieces, the X-Wing fighter will be complete.