Things You'll Need
Instructions
Measure the length of your doll from the shoulder to below the knee, then add 1-inch to this measurement. Measure the width of the doll from shoulder to shoulder and then add 1-inch to this measurement. Cut a paper rectangle (dress pattern) to these new width and length measurements.
Fold your fabric with the right sides touching so the horizontal width from Step 1 forms the shoulders of the dress along the fold. You won't sew any shoulder seams. Place the pattern on the fabric, aligning the top of the pattern rectangle with the fold and pin. Cut the two layers of fabric. Don't cut the fold.
Use the ruler to determine the center of the width measurement (width divided by 2) and cut a vertical line up the center back. Measure the diameter of the doll's head and cut a circle half of this diameter for a neck hole in the center of the top fold of the dress.
Fold the edges on each side of the cut dress back and the neckline over against the wrong side of the fabric 1/4-inch and pin. Sew, using a 1/4-inch seam allowance and a straight stitch. Remove the pins from the hemmed dress back and neckline as you sew.
Align the sides of the rectangle/dress with the right sides of the fabric touching. The dress should be inside out.
Measure the diameter of the doll's arms and add 1/2-inch and divide by 2. Measure, on the dress, from the shoulder fold down the dress sides according to this measurement. Fold the edges of the sleeveless armhole 1/4 inch over against the wrong side of the fabric and pin. Repeat for the other sleeve/side of dress.
Sew using a 1/4-inch seam allowance and straight stitch to hem the sleeveless armholes. Remove the pins.
Align the sides of the dress. Pin the sides beneath the hemmed armholes. Sew each side, using a 1/4-inch seam allowance and straight stitch. Remove the pins.
Fold the bottom edge of the dress over against the wrong side of the fabric, 1/4-inch, and pin. Sew using a straight stitch and 1/4-inch seam allowance. Remove pins.
Place one side of the snap on top of the left upper corner of the divided dress back (on the right side of the fabric) and sew into place with a needle and thread. Place the other section of the snap beneath the top right corner of the divided dress back (on the wrong side of the fabric) and hand sew into place.