How to Build Collectible Doll Storage Display Cases

Take the square wood board (10-inch L x 10-inch W x 1-inch H) and cut a 1-1/4-inch L x 1-1/4-inch W x 1/4-inch H square in each of the four corners. Repeat on the second board.

Take the smaller four square sticks (10-1/2-inch L x 1/2-inch W x 1/2-inch H) and cut each end at a 45 degree angle, 1/4-inch from the end.

Take the larger four square sticks (15-1/2-inch L x 1-1/4-inch W x 1-1/4-inch H) and use a router to cut a 15-inch L x 1/4-inch W x 1/4-inch D slit in the exact middle of each stick. Start and end the cut 1/4-inch from the end.

Take the larger four square sticks again and turn the sticks 90 degrees over to make a second cut, the same as in step 3.

Take the square wood board (10-inch L x 10-inch W x 1-inch H) cut in Step 1 and fit each of the smaller four square sticks cut in Step 2 onto each edge of the board and nail them on. Repeat with the second board.

Take the four square sheets of glass or plastic (15-inch L x 9-inch W x 1/4-inch L) and fit each edge into the slit of the larger four square sticks (15-1/2-inch L x 1-1/4-inch W x 1-1/4-inch H).

Repeat Step 5 until you create a square perimeter with one glass or plastic sheet on each face and one vertical stick in each corner.

Fit the box created in Step 6 into the square wood board (10-inch L x 10-inch W x 1-inch H). Each stick end will fit into each one of the squares cut into one of the boards in Step 5.

Fit the second square board from Step 5 onto the top of the box created in Step 8.