Instructions for Intelli-Table by Fisher-Price

Assembling the Table

• 1

  Turn the red table base upside-down and place it on a flat, dry surface.

• 2

  Insert each table leg into the indicated slots on the sides of the red base. Press down firmly until each leg snaps into place.

• 3

  Turn the assembled table over.

• 4

  Turn the blue play and ring holder over and locate the battery compartment. Use a Phillips-head screwdriver to loosen the screws and remove the battery compartment door. Insert four AA batteries according to the polarity guides shown inside the battery compartment. Replace the battery cover and tighten the screws.

Assembling the Rings

• 5

  Place the blue ring holder upright on a flat surface. Position the play and learn ring into the holder. Using both hands, press down firmly with your thumbs until you hear two clicks, indicating the ring is locked into place.

• 6

  Turn the rings over and slide the "Power/Volume Control" switch to the "On" position. This is the low volume setting. Slide the switch to the "High" position as desired. Turn off the sound by sliding the switch back to the "Off" position.

• 7

  Place the assembled ring into the red table base. Remove the ring for portable fun.

• 8

  Eject the ring from the blue holder as needed. Hold the blue holder with both hands and press the two "Eject" buttons on the bottom. The play and learn ring will unlock and slightly pop up. Remove the ring from the holder.