Hobbies And Interests
Home  >> Toys >> Other Toys

How to Wire a PiccoZ

The Picco Z is a small, ready-to-use RC -- or remote controlled -- helicopter designed for children. Unlike many RC models, there is no building involved. But you'll still need to set up the unit upon purchase. This is done by installing batteries in the remote control. Then you must charge the unit by connecting the charging wire located in the remote control to the engine in the helicopter.

Instructions

    • 1

      Slide the switch in the middle of the remote control to the "Off" position, to turn off the unit.

    • 2

      Slide the compartment cover located just under the "power" switch down, to expose the charging wire.

    • 3

      Remove the charging cable, and plug it into the charging port on the right side of the helicopter unit.

    • 4

      Check the LED light on the remote, to ensure it is flashing. This signals that the unit is charging. The light will turn red when the unit finishes charging.

Other Toys
Other Toys

https://www.htfbw.com © Hobbies And Interests