Hobbies And Interests
Things You'll Need
Instructions
Lay a 2-by-4 plate on a flat surface. Connect a 1-by-2-by-2 brick on the middle two lumps of the four lumps on one side of the 2-by-4 plate.
Attach another 1-by-2-by-2 brick on the two lumps at the edge of the same 2-by-4 plate. One 1-by-2-by-2 brick should be facing and touching the other 1-by-2-by-2 brick.
Connect the lower and upper part of the 1-by-2 hinge brick together. Attach one of the 1-by-2 hinge brick on the two lumps on the other edge of the 2-by-4 plate. The other 1-by-2 hinge brick should swing out like a door.
Attach a 1-by-2 technic brick on top of the 1-by-2 hinge brick that is not attached to the plate. This will act as the door of the safe.
Insert the "3 M.Arch W.Knob And Shaft Ø3.2" into the hole of the 1-by-2 technic brick. This will act as a knob for the door.
Connect a 1-by-2 brick on top of the 1-by-2 hinge brick that is connected to the 2-by-4 plate.
Place a dark gray 1-by-3 plate on both lumps of the 1-by-2-by-2 brick that is on the side of the 2-by-4 plate and on one lump of the 1-by-2-by-2 brick that is on the edge of the 2-by-4 plate.
Attach the lower part and upper part of the dark gray 1-by-2 hinge plate pieces together. Connect one part of the 1-by-2 hinge plates on the two lumps of the 1-by-2 brick that is on top of the 1-by-2 hinge brick that is connected to the plate. Connect the other 1-by-2 hinge plate on top of the 1-by-2 technic brick that is attached to the hinge brick (the door).
Attach a dark gray 1-by-1 plate on the lump of the 1-by-2-by-2 brick on the edge of the 2-by-4 plate.
Connect a dark gray 2-by-4 plate on top of the whole Lego pieces excluding the swinging door. Attach a 2-by-2 flat tile in the middle of the dark gray 2-by-4 plate.
Add other accessories. Connect a 1-by-2 "No. 90" piece on top of the swinging door. Attach a 1-by-2 radiator grille on the sides of the 2-by-2 flat tile. Connect the steering wheel to the knob on the door.