How to Make a Free Tech Deck Ramp & Rails

Cereal Box-Flap Rail

• 1

  Cut the flaps off one side of a cereal box. Keep the long flaps and discard the two short flaps.

• 2

  Measure across each long flap and draw two marks to split the flap into three equal segments. For example, if the flap measures 9 inches long, you will split it into three segments of 3 inches each.

• 3

  Fold the outer segments inward to form a triangle. Apply a piece of duct tape to secure the two ends together. Repeat with the other flap to form two triangles.

• 4

  Pinch any tip of one of the triangles together. Punch a hole between both sides of the tip. Repeat with the other triangle.

• 5

  Slide a pencil through the punched holes of each triangle. Each end of the pencil should protrude ½ inch on the end of each triangle.

• 6

  Apply a small amount of glue onto each end of the triangles where the pencil is protruding. Allow the glue to dry to secure the pencil into place. Start grinding your Tech Deck along your newly created rail.

Cereal Box Ramp

• 7

  Remove the flaps from one side of a cereal box. Position the box so it is flat on a table with the open end facing you.

• 8

  Place a ruler on the top of the box, parallel to you. Place a mark halfway across the box and another mark 4 inches to the left of the first mark.

• 9

  Rotate your ruler so that is running lengthwise along the box. Draw a line down the box at both of the marks you previously made.

• 10

  Cut down each line until you reach the far end of the box. Only cut along the line. Let the center flap you created fall downward. A ramp will be formed.

• 11

  Apply a small piece of duct tape to the end of the ramp closest to you to secure it in place and complete your ramp.