How to Put Together the Vulcan Nerf Gun

Place a towel down on a table. Place the bottom shell of the Vulcan Nerf gun on the towel with the barrel facing to the right.

Reattach the spring into the depression in the bottom shell in the middle directly above the trigger̵2;one end of the spring going into each of the small hubs.

Reattach the small red sprockets to each of the two hubs in the bottom shell in the middle directly above the trigger.

Reattach the belt actuator into the bottom shell in the middle directly above the trigger.

Reattach the white plastic bracket over the belt actuator onto the bottom shell.

Reattach the screws to the white plastic bracket over the belt actuator using the Phillips screwdriver.

Reattach the red sprocket to its position in the front of the bottom shell above the barrel.

Reattach the rubber band onto the end of the bracket and onto the bracket mount directly across from the bracket closest to the magazine chamber.

Reattach the white plastic bracket over the sprocket onto the bottom shell.

Reattach the screws to the white plastic bracket over the sprocket using the Phillips screwdriver.

Place the small orange rectangular bracket horizontally onto the two tabs at the front end of the barrel on the bottom shell.

Reattach the screws to the small orange rectangular bracket using the Phillips screwdriver.

Place the orange magazine clip back inside of the handle at the back of the bottom shell.

Place the top shell back onto the bottom shell.

Reattach the screws to the top left, middle and right sides of the top shell with the Phillips screwdriver.

Reattach the screws to the front bottom of the barrel and around the bottom magazine chamber with the Phillips screwdriver.

Reattach the screws to the handle at the back bottom with the Phillips screwdriver.