Things You'll Need
Instructions
Place the Nerf Titan on its side on a table, with the barrel facing to the left.
Remove the screws from both sides of the barrel of the Nerf Titan using the jeweler's Phillips-head screwdriver.
Remove the screws from the around the hammer of the Nerf Titan using the jeweler's Phillips-head screwdriver. Remove the screws from around the barrel of the Nerf Titan using the jeweler's Phillips-head screwdriver.
Insert the jeweler̵7;s flat-edged screwdriver into the seam between one side of the Nerf Titan and the other side. Wiggle the tip of the jeweler̵7;s flat-edged screwdriver into the seam to separate the two halves from each other.
Repeat this process with the jeweler̵7;s flat-edged screwdriver in the seam between the two halves on both sides of the gun stock, by the hammer, at the front of the barrel and on the sides of the Nerf Titan.
Insert the tip of the flat-edged screwdriver into the gap where a small rod sticks out from the back by the hammer.
Wiggle the tip of the flat-edged screwdriver to loosen the left and right sections of the loader from each other. Pull the left and right sections apart with your hands. Place the left and right sections of the loader aside.
Lift the top shell of the Nerf Titan off the bottom shell using your hands. Place the top shell aside.
Insert the tip of the jeweler̵7;s flat-edged screwdriver beneath the loader that is at the back of the Nerf Titan by the hammer. Wiggle the tip of the flat-edged screwdriver beneath the loader to loosen it. Lift off the loader using your fingers.
Pull out the small rod from the top of the loader using your fingers. Place the small rod and the loader aside.
Insert the tip of the flat-edged screwdriver beneath the white plastic insert beneath the barrel. Wiggle the tip of the flat-edged screwdriver to loosen the white plastic insert. Pull the white plastic insert out with your fingers.
Repeat this procedure with the white plastic insert that is at the back of the bottom shell, across from the white plastic insert that was just removed. Place both of the white plastic inserts aside.
Grip the front of the barrel with your fingers. Slide the barrel out from the bottom shell and put it aside.
Pull the small spring off of the small black bracket that is above the position where the first white plastic insert was, using the needle-nose pliers. Place the small spring aside.
Insert the tip of the jeweler̵7;s flat-edged screwdriver beneath the small black bracket.
Wiggle the tip of the flat-edged screwdriver to remove the small black bracket from the nub it is resting on. Place the small black bracket aside.
Pull the large spring off the spring assembly using the needle-nose pliers. The large spring is positioned above where the small black bracket was. Place the large spring aside.
Insert the tip of the jeweler̵7;s flat-edged screwdriver beneath the spring assembly. Wiggle the tip of the flat-edged screwdriver to loosen the spring assembly from the bottom shell.
Pull the spring assembly off of the bottom shell with your fingers. Place the spring assembly aside.